Clincher SFPlant Protection Product ComparisonPlant Protection Product ComparisonReport inaccuraciesReport inaccuracies

Registratration Number: 62719-357
States available in: AL AK AZ AR CO CT DE FL GA HI ID IL IN IA KS KY LA ME MD MA MI MN MS MO MT NE NV NH NJ NM NC ND OH OK OR PA RI SC SD TN TX UT VT VA WA WV WI WY

Clincher^® SF is a postemergence grass herbicide for control of a wide spectrum of annual and seedling perennial grasses in rice. It fits well into both dry- and water-seeded rice and may be tank-mixed with residual herbicides for longer control of problem grasses.

Tank Mixes
Clincher® SF herbicide can only be tank-mixed with NEWPATH, CLEARPATH, BEYOND, Command, Grasp® SC, FACET or PROWL herbicides, as well as fungicides and insecticides. Follow label directions on each respective product label.
Tank-mixing with nonrecommended herbicides may reduce overall grass control.
Tank-mixing with Grasp SC may reduce control of broadleaf signalgrass.

Water Management
Early post application: Apply to muddy soil. Drought stress will reduce weed control. Flush fields as necessary to prevent drought-stress conditions to weeds and crop.
Post-flood application: Weed foliage must be at least 70 percent exposed from water. Will not control submerged grasses. Apply seven to 14 days following permanent flooding of field. Later applications should be considered rescue treatments, and satisfactory grass control may not be obtained.

Application Precautions and Tips
For heavy grass densities and/or rescue treatments, sequential application is recommended. Follow the initial 15-oz. application with a sequential 10-oz. application within 10 to 14 days for improved control.
If Clincher SF is applied as a post-flood salvage treatment to previously untreated areas, fields with previous failed herbicide applications, or areas of extremely high grass weed density, total control of labeled grass weeds should not be expected. Regrowth of these grass weeds may occur.
Always use clean water with spray mixes of Clincher SF. Do not use water containing rinsate from previous spray solution, even at low concentrations, as this may reduce weed control.
If drift control agent is used, weed control may be reduced.
Apply at least five days before or seven days after the application of broadleaf or sedge herbicides.
If the spray solution pH is >8, a buffering agent should be used to lower the pH to <8.
For best control, apply when weeds are actively growing and not under stress.
Corn, milo, sugarcane, other grasses, nectarines and peaches are sensitive to Clincher SF.
Cotton, soybeans, tomatoes and other leafy vegetables are not sensitive to Clincher SF.

Directions for Use
It is a violation of Federal law to use this product in a manner inconsistent with its labeling. Read all Directions for Use carefully before applying. Do not apply this product in a way that will contact workers or other persons, either directly or through drift. Only protected handlers may be in the area during application. For any requirements specific to your state or tribe, consult the agency responsible for pesticide regulation.

Legal Requirement
Before using any pesticide, be sure it is registered for use in your state or locality. Clincher SF is registered for use in AR, FL, LA, MO, MS, TN and TX only. Do not tank mix other rice herbicides with Clincher SF as reduced grass control may occur. Do not apply to drought-stressed weeds, as efficacy may be reduced. Symptoms: New leaves will stop growing and die first. No bleaching or desiccation will occur. Clincher SF takes about 10-21 days for full efficacy. Avoid drift to corn, sorghum, sugar cane and peaches. Buffer zones apply. Please refer to the label. Always read and follow label directions.

Active